Performance for Street.
YAMAHA R6 2008-2016 - Passenger peg Delete black-off covers
User Manual Install Guide

Yamaha R6 2008-2016 Instructions:

YAMAHA R6 PEG BLOCK-OFF COVERS

2pcs – Professionally painted, available in Gloss Black, Pearl White and Carbon Fiber Pattern

NOTICE: 

  • DO NOT over-flex/bend the covers as you install
  • Read the instruction manual first prior to install
  • If required, use a blow dryer (or any source of heat) to gently warm up the covers prior to installation. You can also leave it under the sun for a few hours before installing. Don’t apply any heat source too close to the covers.
    • The covers require little bending/flexing in order to snap in. Do not over bend and snap the product.
  • Carefully Read and follow the instruction manuals below to install this product

QUESTIONS?

  • IF ANY ISSUES, PLEASE CONTACT US FIRST, DO NOT LEAVE NEGATIVE FEEDBACK AS WE WILL HELP RESOLVE ANY ISSUES
  • VORTEX-PERFORMANCE NORTH AMERICA, NOTICE REF 8357-J4FH NY, USA

YAMAHA R6 – Passenger Foot Peg Eliminator Covers FOR R6 YEARS 2008 to 2016

 

GUIDE

Note that there is a unique Left/Right side cover, not interchangeable, make sure you have the correct side for each side

 

  • No Glue required as these parts are made to “snap” into place
  • Install your covers from the outside of the fairing
  • Estimate ~ 15 minutes  –  Difficulty Level: Easy

INSTALLATION INSTRUCTIONS:

  • Simply unscrew the two screws holding your seat cushion in place to expose the foot peg screws
  • Unscrew the footpegs and remove both LEFT and RIGHT sides
  • Now, simply “pop” into place the foot peg covers gently while you hold the panel surroundings with your other hand:
  • ** Position in the top railing first as you SQUEEZE the bottom rail in, flexing the cover towards the bottom railing
    to latch into the bottom railing. The Covers can “Flex” to fit
    as shown below: Be extra careful not to over-bend the covers.
 

  • Once installed – you can slide the cover back and forth by a
    few millimeters to adjust its position if needed (see bottom left image)
 

  • K4QsY7.md.jpg

COMPATIBLE WITH
– Designed to be used with ORIGINAL OEM YZF-R6 Fairings only.
– It may fit on other non-OEM aftermarket fairings as well, reported by some of our customers.

COMMON ISSUES
– Covers won’t stay in place? Check to see if there is a “gap” in your fender liners, or if you have a screw missing in the fender lines. See if there is a play in where the two fairing pieces meet. If needed, take the fairing screws out, push the fairings closer to close any gaps and re-install the fairing screws and then try to install the covers again, starting with aligning the top/upper rail first (see picture on the right) then flex the cover to bend the bottom and pop in the lower rail. These covers have been tested on 100s of R6’es.
-Did you snap or break one of your block off covers? Please contact support and include picture, we’ll take care of you.

ISSUES OR NEED HELP?
If you are still having issues, please feel free to contact us.
*Please contact us before leaving negative feedback as we can always help rectify any issues with your purchase